Skip to content

EQ

Dynamic EQ explained

A dynamic EQ is an EQ band that moves by itself: it cuts or lifts only while the sound is too loud in that one range, and lets go when it is not. Use it for a problem that comes and goes, like a sharp ess, one boomy note, or a bass that should dip only while the kick hits.

A dynamic band at 7 kHz with a range of five decibels, cutting only while an ess hits

What a dynamic band does

An ordinary EQ band is a fixed move. Cut 4 dB at 7 kHz and every moment of the track loses 4 dB there, the esses and the breath between them alike.

A dynamic band listens first. While the sound in its own range stays under a level, the band does nothing. When it goes over, the band moves, as far as the sound went over, up to a limit you set. When the sound drops, the band comes back. The picture above is a band on a sung line that cuts at 7 kHz only while an ess hits.

When it helps

  • Esses and hard consonants. They are loud for a moment and gone. A dynamic cut between 5 and 8 kHz catches them and leaves the rest of the word bright.
  • One note that booms. A bass or a guitar often has one note that rings louder than its neighbors. A narrow dynamic cut on that note turns it down only when it is played.
  • Cymbals and hats that bite. A dynamic cut near 4 kHz softens the hard hits and leaves the quiet ones crisp.
  • Two sounds in one range. With a sidechain, the band listens to another track, so the bass dips at 60 Hz only while the kick hits.
  • A lift that should not get harsh. A dynamic band can push up as well as pull down: add air to a vocal that backs off when she leans in.
A dynamic band at 4 kHz with a range of four decibels, cutting only while the hats bite

One move to try

Put a bell where the problem is, as you would for a normal cut, and leave its gain at zero. Turn the band dynamic and give it a range of minus 4 to minus 6 dB. Play the loud part and watch the band: it should move on the problem and sit still on everything else. If it moves all the time, the range is doing a normal cut’s job, so use a normal cut.

Let another track trigger it

A dynamic band can listen to a different track than the one it is on. Route the kick to the EQ’s sidechain input on the bass, set the band at the kick’s note, and the bass dips there only while the kick hits. The low end stays full between hits, and the two stop fighting for the same space.

A dynamic band at 60 Hz keyed from the kick, its range six decibels, the kick drawn as a second trace in the display

Going further

Start with the automatic settings. In Neutral EQ a dynamic band sets its own threshold from the sound’s usual level, and its release lets go fast after a short hit and slowly after a long push. Turn either off to set it by hand. The dynamic bands page has every control.

It is still an EQ. Below its threshold a dynamic band is the plain band you drew, so turning Dynamic off and on is a fair comparison.

Small ranges. Four to six decibels solves most problems. A range of 12 dB on a vocal is a sign the fix belongs earlier: the take, the microphone, or the level going in.

Questions people ask

What is dynamic EQ?

An EQ band whose gain moves with the sound. An ordinary band cuts the same amount all the time. A dynamic band cuts, or lifts, only while the sound in its range goes over a level you set, and returns to where it was when the sound drops.

What is the difference between dynamic EQ and multiband compression?

They do a similar job in different shapes. A multiband compressor splits the sound into a few wide ranges and turns each one down as a whole. A dynamic EQ moves one band with the shape, frequency and width you drew, so it can be as narrow as one ringing note. Reach for dynamic EQ when the problem is in one place.

When should I use dynamic EQ and not a normal EQ?

When the problem comes and goes. If a vocal is harsh on every word, a normal cut fixes it. If it is harsh only on loud words, a normal cut dulls the quiet ones, and a dynamic band leaves them alone.

Made in Neutral EQ on the sessions built for the vocal, bass and drum pages. Every picture is the plugin as it was set.